EasyManuals Logo

HP Z210 User Manual

HP Z210
185 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #157 background imageLoading...
Page #157 background image
Table 6-9 POST error messages (continued)
Screen message Probable cause Recommended action
1720—SMART Hard Drive
Detects Imminent Failure
Hard drive is about to fail. (Some hard
disk drives have a firmware patch that
fixes erroneous error messages.)
1. Determine if the hard disk drive is giving a correct
error message.
2. Run the Drive Protection System test (if
applicable).
3. Apply firmware patch (if applicable). See
http://www.hp.com/support.
4. Back up contents and replace the hard disk drive.
1783—Fixed Disk 0/1 locked Hard disk drive failure. Diagnose the hard disk drive, and replace it if
necessary.
1796—SATA Cabling Error Missing or improperly attached cable. Verify that a cable is attached. Reattach the cable.
1797—SATA Drivelock is not
supported in RAID mode
SATA Drivelock is not supported in
RAID mode.
Disable RAID mode, or disable SATA drivelock..
1801—Microcode Update
Error
Unknown or unsupported processor
stepping.
The microcode update failed. Check the processor
stepping to ensure it is a supported stepping. If it is
contact, HP Support.
1802—Processor Not
Supported
The system board does not support the
processor.
Replace the processor with a compatible one.
1803—Processor feature set is
insufficient for current system
settings
Processor feature set is insufficient for
current system settings. The BIOS
settings do not match the support
provided by the processor
Change the BIOS settings or upgrade the processor.
1804—A processor feature
and the memory configuration
are incompatible
A processor feature is incompatible
with the memory configuration.
Restore the previous memory configuration.
ERROR: Invalid 1394 GUID
(Invalid electronic serial
number)
No electronic serial number is stored
with the system.
To assign a serial number , select Security >System
IDs in the Computer Setup (F10) Utility.
ERROR: Invalid electronic
serial number (no number)
No electronic serial number is stored
with the system
To assign a serial number , select Security >System
IDs in the Computer Setup (F10) Utility.
ERROR: An unsupported
processor is installed. System
halted
Unsupported processor detected. Replace the processor.
ERROR: A processor requiring
too much power is installed.
System halted
Unsupported processor detected. Replace the processor.
Invalid electronic serial
number
Incorrect serial number registered in
the system.
To assign a serial number , select Security >System
IDs in the Computer Setup (F10) Utility.
Network Server Mode Active
and No Keyboard Attached
Keyboard not detected. Verify that a functioning keyboard is attached to the
computer.
Processor initialization fails Processor defective. Replace the processor.
ENWW
Diagnostic codes and errors
145

Table of Contents

Other manuals for HP Z210

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the HP Z210 and is the answer not in the manual?

HP Z210 Specifications

General IconGeneral
Tcase72.6 °C
Bus typeDMI
SteppingD2
FSB ParityNo
Processor cache6 MB
Processor cores4
Processor modelE3-1225
System bus rate5 GT/s
Processor seriesIntel Xeon E3-1200
Processor socketLGA 1155 (Socket H2)
Processor codenameSandy Bridge
Processor frequency3.1 GHz
Processor cache typeSmart Cache
Processor lithography32 nm
Processor manufacturerIntel
Processor front side bus- MHz
PCI Express slots version2.0
Processor boost frequency3.4 GHz
Processor operating modes64-bit
ECC supported by processorYes
Thermal Design Power (TDP)95 W
Number of processors installed1
CPU multiplier (bus/core ratio)31
Maximum number of PCI Express lanes20
Memory types supported by processorDDR3-SDRAM
Memory clock speeds supported by processor1066, 1333 MHz
Memory bandwidth supported by processor (max)21 GB/s
Maximum internal memory supported by processor32 GB
Graphics cardQuadro 600
Dimensions (WxDxH)100 x 381 x 338 mm
Networking featuresGigabit Ethernet (10/100/1000)
Graphics card familyNVIDIA
Maximum internal memory16384 MB
Graphics card manufacturerNvidia
Audio systemALC261
Product typeWorkstation
Motherboard chipsetIntel® C206
Memory slots4x DIMM
Internal memory8 GB
Memory channelsDual-channel
Memory clock speed1333 MHz
Memory layout (slots x size)- GB
HDD speed- RPM
RAID levels0, 1
HDD capacity500 GB
SSD capacity160 GB
HDD interfaceSATA II
SSD interfaceSATA
Optical drive typeDVD-RW
Total HDDs capacity1000 GB
Card reader integrated-
Number of HDDs installed2
Maximum graphics card memory1.024 GB
On-board graphics card modelIntel® HD Graphics P3000
On-board graphics card familyIntel® HD Graphics
On-board graphics card base frequency850 MHz
On-board graphics card dynamic frequency (max)1350 MHz
USB 2.0 ports quantity14
USB 3.2 Gen 1 (3.1 Gen 1) Type-A ports quantity0
Chassis typeSFF
Product colorBlack
Country of originChina
Compatible operating systemsWindows 7
Power supply240 W
CertificationENERGY STAR 5.0
Processor codeSR00G
Processor ARK ID52270
Processor package size37.5 x 37.5 mm
Supported instruction setsAVX, SSE4.1, SSE4.2
Intel Identity Protection Technology version1.00
Weight and Dimensions IconWeight and Dimensions
Depth381 mm
Width100 mm
Height338 mm
Weight7600 g

Related product manuals