HP Z210

7 Configuring RAID devices
This chapter describes how to configure SATA RAID devices on all Z-series workstations and includes
these topics:
Topics
Maximum RAID hard drive configurations on page 146
Configuring SATA RAID devices on page 147
For additional information about configuring RAIDs, see http://www.hp.com/support/RAID_FAQs. For
information about preparing the computer for RAID configuration, see
http://www.hp.com/support/
workstation_manuals.
Maximum RAID hard drive configurations
This section lists the maximum number of hard drives supported on HP workstations for RAID
configurations.
NOTE: This section applies to internal workstation configurations that do not use add-in cards and
JBODs.
TIP: Use the table values to determine the workstation model-specific maximum number of hard drives
as discussed in the sections below.
Table 7-1 Maximum hard drives
Workstation 8.5mm (3.5") SATA
hard drive
6.3mm (2.5") SATA
hard drive
Z800 5 6
Z600 3 4
Z400 4 4
Z210 CMT 3 3
Z210 SFF 2 2
146 Chapter 7 Configuring RAID devices ENWW