HP Z210

Memory
This section presents memory module (DIMM) configuration information and removal/installation
procedures.
Supported DIMM configurations
The workstation supports these DIMM configurations:
●
Four DIMM slots
●
Memory configuration from 1 GB to 32 GB
●
No support for mirroring
●
No support for DIMM sparing
●
Error checking and correcting (ECC) and non-ECC DIMMs are supported.
DIMM installation guidelines
●
Install only HP-approved DDR3 DIMMs.
CAUTION: HP ships only DIMMs that are electrically and thermally compatible with this
workstation. Because third-party DIMMs might not be electrically or thermally compatible, they are
not supported by HP.
●
For ECC DIMMs, use only industry-standard ECC unbuffered DIMMs. See
http://www.hp.com/
go/quickspecs to find which DIMMs are compatible with the workstation.
●
Do not intermix non-ECC memory DIMMs with ECC memory DIMMs.
DIMM installation order
Review the following to determine the correct installation order for DIMMs.
Figure 5-24 DIMM load order
ENWW
Removing and installing components
83