network example 1
Network -- "IP address change has not been completed"
network suggested action 1
The setnet command was issued to change some network parameter, such as the IP address, but the
action has not been completed. Use setnet finish to complete the change, or setnet abort to
cancel. Use shownet to examine the current condition.
cli% shownetIP Address Netmask/PrefixLen Nodes Active Speed Duplex AutoNeg
Status
192.168.56.209 255.255.255.0 0123 0 100 Full Yes Changing
192.168.56.233 255.255.255.0 0123 0 100 Full Yes Unverified
network example 2
Component ---Identifier---- -----Detailed Description----------
Network Node0:Admin Errors detected on network
network suggested action 2
Network errors have been detected on the specified node and network interface. Commands such as
shownet and shownet -d are useful for troubleshooting network problems. These commands display
current network counters as checkhealth compares error with the last logging sample.
NOTE: The error counters shown by shownet and shownet -d cannot be cleared except by rebooting
a controller node. Because checkhealth is comparing network counters with a history log,
checkhealth stops reporting the issue if there is no increase in error in the next log entry.
cli% shownet -dIP Address: 192.168.56.209 Netmask 255.255.255.0
Assigned to nodes: 0123
Connected through node 0
Status: Active
Admin interface on node 0
MAC Address: 00:02:AC:25:04:03
RX Packets: 1225109 TX Packets: 550205
RX Bytes: 1089073679 TX Bytes: 568149943
RX Errors: 0 TX Errors: 0
RX Dropped: 0 TX Dropped: 0
RX FIFO Errors: 0 TX FIFO Errors: 0
RX Frame Errors: 60 TX Collisions: 0
RX Multicast: 0 TX Carrier Errors: 0
RX Compressed: 0 TX Compressed: 0
pd
Displays physical drives (PDs) with states or conditions that are not optimal:
• Checks for failed and degraded PDs
• Checks for an imbalance of PD ports, for example, if Port-A is used on more Drives than Port-B
Troubleshooting 153
To Next Page
Loading...
