• Secure Boot and remains enabled.
• The Secure Boot Database is not restored to its default state.
• iSCSI Software Initiator configuration settings are not restored to defaults.
Embedded UEFI shell
The system BIOS includes an Embedded UEFI Shell in the ROM. The UEFI Shell environment provides an
API, a command-line prompt, and a set of CLIs that allow scripting, file manipulation, and system information.
These features enhance the capabilities of the UEFI System Utilities.
For more information, see the following documents:
• UEFI Shell user guide on the Hewlett Packard Enterprise website
• UEFI Shell Specification on the UEFI website
Embedded Diagnostics option
The system BIOS includes an Embedded Diagnostics option in the ROM. The Embedded Diagnostics option
can run comprehensive diagnostics of the server hardware, including processors, memory, drives, and other
server components.
For more information on the Embedded Diagnostics option, see the UEFI System Utilities user guide for your
server on the Hewlett Packard Enterprise website.
Re-entering the server serial number and product ID
About this task
After you replace the system board, you must re-enter the server serial number and the product ID:
Procedure
1. During the server startup sequence, press the F9 key to access UEFI System Utilities.
2. Select System Configuration > BIOS/Platform Configuration (RBSU) > Advanced Options >
Advanced System ROM Options > Serial Number, and then press the Enter key.
3. Enter the serial number and press the Enter key.
The following message appears:
The serial number should only be modified by qualified service personnel. This
value should always match the serial number located on the chassis.
4. To clear the warning, press the Enter key.
5. Enter the serial number and press the Enter key.
6. Select Product ID.
The following warning appears:
Warning: The Product ID should ONLY be modified by qualified service
personnel. This value should always match the Product ID located on the
chassis.
7. Enter the product ID and press the Enter key.
8. To confirm exiting System Utilities, press the F10 key.
The server automatically reboots.
58 Embedded UEFI shell
To Next Page