HTC 1500 IXT - Page 24

Machine description
HTC 1500 ixT
14 3.0
Joystick for movement forwards/backwards (FORWARD/
REVERSE)
• Push the joystick away from you to move the machine
forwards. Pull the joystick towards you to move the
machine backwards.
Controls for adjusting steering (OFFSET)
• Turn the control to the left/right to adjust any veering
tendencies, see Figure 3-3 on page 13.
Knob for lifting/lowering the grinding head (LIFT)
• Turn the knob to "UP" to lift the grinding head. Turn to
"DOWN" to lower the grinding head and for "moving
position".
Control for rotation speed (SPEED)
• Turn the knob to "+"/"-" to increase/reduce the rotation
speed of the machine's grinding discs.
Knob for starting/stopping the rotation of the grinding
discs (GRINDING)
• Turn the knob to "I" to start the grinding discs' rotation.
Turn the knob to "O" to stop the rotation.
Ignition key (POWER)
• Turn the ignition key to "I" to activate the machine's
functions and prepare for starting. Turn the ignition key to
"O" to switch off the machine's functions.
Emergency stop switch (EM-STOP)
• Press the switch in an emergency to cut the power to the
machine.
Display
The display shows power consumption for the grinding motor that
uses the most power during use. You can also view information on
the speed of the machine, the rotation speed of the grinding discs,
error codes, etc.