HTC 1500 ixT
Operation
3.0 25
4.6. Handling Longopac
The dust separator is equipped with Longopac-brand refuse bags,
which are sealed and discarded once the maximum amount of dust
is reached.
4.6.1. Removing the full refuse bag
1. Seal the filled bag with a tie at the top.
2. Seal the new bag with a tie at the bottom.
3. Cut off the bag between the ties.
Figure 4-4 Cut off the bag
4. Discard the full bag.
5. Pull down the roll of bags to the recommended length,
around 500 mm.
4.6.2. Fitting Longopac
1. Loosen the clip around the bottom cone.
2. Lift the Longopac holder slightly and turn it until it loosens
from its fitting.
To Next Page
Loading...
