Operation
HTC 1500 ixT
32 3.0
connecting the machine to the mains power. For instance, you can
transport the machine around 500 mm, raise/lower the grinding
head and the dust separator and turn on the headlight and work
light.
Note!
Leakage currents can run down the batteries, as the batteries are
exposed to dust. Keep the batteries clean to avoid discharging.
4.11.1. Charging the battery
The batteries are charged automatically when the machine is
connected to mains power. It takes around two hours until the
batteries to be fully charged.
The batteries can also be charged through a 16A three-phase socket
using the charging cable that accompanies this machine.
Warning!
During charging, oxyhydrogen gas always forms in the battery. An
open flame or spark in the vicinity of the batteries could cause an
explosion.
Note!
The charging cable for the three-phase socket must only be used
for charging and must not, under any circumstances, be used for
grinding .
To Next Page
Loading...
