Operation
HTC 1500 ixT
36 3.0
Figure 4-10 Foot marks
6. Start the dust separator.
7. Turn the ignition key to "I".
8. Check that the grinding head is lowered.
9. Adjust the speed of the grinding discs.
10. Start the grinding discs rotating.
11. The machine is now ready for use.
4.13.4. Stopping the machine
1. Stop the grinding discs rotating.
2. Switch off the dust separator.
3. Turn the ignition key to "O".
4. Wind the cable by pulling on it so that the locking catch
releases. The cable rewinds by means of the spring force of
the cable winder.
To Next Page
Loading...
