HTP MODCON1000 - Resetting the Maintenance Schedule; Part 10 - Start-Up Procedures for the Installer; Boiler Control Status Menu

LP-428 Rev. 6.6.16
46
NOTE: For the following functions, you must have your
maintenance function turned on.
To change these functions, press ENTER. The left most digit
will begin to blink. Use the ^ or v arrows to change the digit.
Use the < > arrow keys to switch between digits. When you’ve
made your selection, press ENTER again.
Screen Description
Function 33 Year
SERVICE SCHEDULE
YEAR 00/00/2000 33
Allows the user to set the year of the
next service reminder.
Hours
SERVICE SCHEDULE
10000’s
000000 33
Allows the user to set the left two
digits of the amount of run hours
before next service reminder.
Function 34 Month
SERVICE SCHEDULE
MONTH 00/00/2000 34
If the date function was selected,
this function programs the month. If
you selected the run hour function,
you will need to program 10,000
hours, if required.
Hours
SERVICE SCHEDULE
10000’s 00
0000 34
Allows the user to set the middle
two digits of the amount of run
hours before next service reminder.
Function 35 Day
SERVICE SCHEDULE
DAY 00/00/2000 35
Sets the day of next service
reminder.
Hours
SERVICE SCHEDULE
10000’s 0000
00 35
Sets the two right digits of the
amount of run hours for the next
service reminder.
Function 36 Telephone
TELEPHONE #
000 000 0000 36
Allows the user to input a telephone
number that will display when
maintenance is required.
Table 17 - Maintenance Reminder Function Screens
G. Resetting the Maintenance Schedule
When the system control ashes MAINTENANCE REQUIRED,
it is advisable that you call for service. After the service is
performed, reset the schedule for the next required service by
using the following steps.
Press ENTER on the display for 3 seconds. The Menu code
will appear as 000. This does not change. Press ENTER again.
SERVICE SCHEDULE RESET will be displayed. Using the > key
scroll to the selection of year or hours. Press ENTER to reset
the selected Service Schedule. To change a setting, press
ENTER. Press the ^ and v keys to make adjustments. Press
ENTER when reset is complete.
Part 10 - Start-Up Procedures for the Installer
A. Boiler Control Status Menu
The boiler control also has the ability to review system
status. To access the status screens, press >. Once the rst
value is displayed, press ^ and v to scroll through additional
information. At any point press RESET to exit the status
screens.
Table 18 - Heating Curve - NOTE: The user can adjust the heat curve
down by lowering the central heating temperature.
Screen Description
SUPPLY SEN 180
o
F
RETURN SEN 150
o
F
This is the rst screen that appears
after pressing >, and shows the
actual temperatures measured
by the supply and return sensors.
NOTE: If the boiler is congured to
use a 0 – 10 volt input, the return
sensor is disabled and the second
line of the display will be blank.
Press v once.