NOTE
The cable management strip holder, cable management strip, protective units, and M6 screws are not
included in the installation accessory package delivered with a card and need to be purchased separately.
Procedure
Step 1 Use a Phillips screwdriver and M6 screws to fix the cable management strip holder onto
mounting rails of the cabinet, as shown in Figure 6-6.
Figure 6-6 Installing the cable management strip holder onto the cabinet
Step 2 Put the unshielded network cable connected to the local device through the cable inlet at one
side of the cable management strip holder, and put the unshielded network cable connected to
the remote device through the cable inlet at the other side of the cable management strip
holder. See Figure 6-7.
Huawei
AR100&AR120&AR150&AR160&AR200&AR1200&AR
1600&AR2200&AR3200&AR3600 series Enterprise
Routers
Hardware Installation and Maintenance Guide
6 Installing the AR1200 Series/AR2204/AR2220E/
AR2220/AR2204E Series Routers
Issue 05 (2018-07-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
81
To Next Page
Loading...
