a. In the navigation tree, choose LAN > DHCP Server Configuration.
b. In the right pane, click the check box of Enable DHCP L2Relay.
NOTE
If Bridge Type of the WAN port is set to PPPoE_Bridged, DHCP relay does not need to be
enabled. If Bridge Type is set to IP_Bridged, DHCP relay must be enabled.
c. Click Apply to apply the configuration.
5. Save the configuration.
In the navigation tree, choose System Tools > Configuration File. In the right pane,
click Save Configuration to save the configuration.
l Configure the ONT on the U2000.
Layer 3 bridge mode is used for connecting the ONT to the upper-layer device and
parameters of a WAN port must be configured.
The following uses batch configurations of creating a value-added service profile of the
ONT as an example. To configure an ONT, on the GPON ONU tab page, select an ONT,
right-click, and choose Configure Value-Added Service from the shortcut menu.
1. Log in to the NMS (iManager U2000 V100R003C00) and start the FTP service.
2. Configure the value-added service profile of the ONT.
a. From the main menu, choose Configuration > Access Profile Management. In
the navigation tree of the tab page that is displayed, choose PON Profile > ONT
VAS Profile.
b. On the ONT VAS Profile tab page, right-click, and choose Add from the shortcut
menu.
c. In the dialog box that is displayed, set relevant parameters.
– Profile Name: ONT-IPTV
– Vendor ID: HWTC(2011)
– Terminal Type: 247
– Version: V1R002C06-Later
EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual 3 Configuration
Issue 02 (2011-12-08) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
198
To Next Page
Loading...
Need help?
General
