Prerequisite
l The Layer 2 service channels between the OLT and ONTs are enabled by running the OLT
commands. For details, see Enabling Layer 2 Service Channels Between an OLT and
a GPON ONT (on the OLT CLI).
l You have established the environment for logging in to the Web page for service
configuration and have successfully logged in to the Web page. For details, see 3.4.3
Locally Logging in to the Web Interface.
l A portable computer with the Wi-Fi function must be available.
Context
The Wi-Fi wireless access service includes the Layer 3 bridge Wi-Fi service and the Layer 3
route Wi-Fi service.
l Layer 3 Wi-Fi service: Search for the SSID is performed on the PC. After the user passes
the verification, the PPPoE auto dialup is performed on the PC. The IP address is allocated
by the upper-layer BRAS. The ONT is connected to the OLT and then to the upper-layer
network in the Layer 3 mode to provide the high-speed Internet access service.
l Layer 3 route Wi-Fi service: Search for the SSID is performed on the PC. After the user
passes the verification, the PPPoE auto dialup is performed on the PC. The ONT is
connected to the OLT and then to the upper-layer network in the Layer 3 mode to provide
the high-speed Internet access service.
Procedure
l Layer 3 bridge Wi-Fi service
1. Configure the Wi-Fi parameters.
a. In the navigation tree, choose Wi-Fi > Wi-Fi Basic Configuration.
b. Select Enable Wireless to enable the Wi-Fi function. Then, set the parameters
as follows:
– SSID: ChinaNet-huawei
– Authentication Mode: WPA Pre-Shared Key
– Encryption Mode: TKIP&AES
– WPA PreSharedKey: chinahuawei
EchoLife HG8010/HG8110/HG8240/HG8245/HG8247/
HG8447 GPON Terminal
Service Manual 3 Configuration
Issue 02 (2011-12-08) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
229
To Next Page
Loading...
Need help?
General
