Parameter Description Setting
URI Specifies the uniform resource
identifier (URI) of the site, for
example, abcd@huawei.com.
NOTE
This parameter available only when
Type is set to IP, H.323, or SIP.
No default value is set for this
parameter.
Country/Region
code
Specifies the country or area where
your TE30 is located.
This parameter is mandatory when
Type is set to ISDN or PSTN.
No default value is set for this
parameter.
Area code Specifies the area code for the site.
Set this parameter based on the
Country/Region code value.
This parameter is mandatory when
Type is set to ISDN or PSTN.
No default value is set for this
parameter.
Line 1 #1
Line 1 #2
Line 2 #1
Line 2 #2
Line 3 #1
Line 3 #2
Specify the numbers your TE30
uses to call the site. These
parameters are available only for
ISDN sites. You can set two
numbers for each BRI line.
l When the ISDN site rate is set to
a value ranging from 64 kbit/s to
512 kbit/s, set Line 1 #1 only
because you only need to dial
that number to call the site.
l If the ISDN site rate is set to 2,
3, 4, 5, or 6 x 64 kbit/s, set the
other required parameters as
well because you need to dial the
BRI line numbers one by one to
call the site. Line 1 #2 specifies
the second number of the first
BRI line.
No default value is set for these
parameters.
Step 5 Select Save.
The new site is listed in Address Book.
----End
Creating a Group
If certain sites regularly join the same conference, you can define these sites as a group.
Step 1 On the Address Book screen, select All Groups.
HUAWEI TE30 Videoconferencing Endpoint
User Guide 6 Conference
Issue 01 (2013-03-27) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
60
To Next Page
Loading...
Need help?
General
