Installation Manual
Quidway S3000-EI Series Ethernet Switches Chapter 1 Product Introduction
1-3
II. Front panel indicators
The meanings of the indicators on the front panel of S3026G are described in the
following table.
Table 1-1 S3026G Switch front panel indicators
Indicator Panel indication Status Description
On The switch is powered on.
PRW
Off The switch is powered off.
On Redundant power is working
System state
indicator
RPS
Off Redundant power is not working
On/Blinking Data is being sent or received.
LNK
Off No data is being sent or received.
On Full-duplex mode
DUP
Off Half-duplex mode
On 100M operating mode
Fixed 100M
Ethernet port
indicators
SPD
Off 10M operating mode
III. Fixed 100M Ethernet ports on the front panel
Table 1-2 Attributes of the fixed 100M Ethernet ports of S3026G Switch
Attribute Description
Connector
RJ-45
Interface number
24
Operating mode
10M half-/full-duplex
100M half-/full-duplex
MDI/MDI-X auto-sensing
Compliant standard
IEEE 802.3u
Transmission medium and
maximum transmission distance
Category-5 twisted pair cabling with a maximum transmission distance of
100m.
IV. Console port
S3026G Switch provides a Console port compliant with EIA/TIA-232 asynchronous
serial criterion. Users can perform local or remote configuration of the switches via
this port.
Table 1-3 Console port attributes
Attribute Description
Connector
RJ-45
Standard of
interface
Asynchronous EIA/TIA-232
Baud rate
9600bps ( by default )
Services supported
Connect with character terminal
Connect with the serial port of a local terminal (which can be a PC) or a remote
terminal (through a pair of Modems) and run terminal emulation program on a
terminal.
To Next Page
Loading...
