Huawei Quidway S3000-EI Series - 2.2 Setting up Configuration Environment through Telnet; 2.2.1 Connecting a PC to the Switch through Telnet

Installation Manual
Quidway S3000-EI Series Ethernet Switches Chapter 1 Product Introduction
1-5
1.3 S3026C/S3026C-DC Ethernet Switches
1.3.1 Front Panel
 Note:
The layouts of the front panels of S3026C and S3026C-DC Switches are exactly same. This section will
introduce the front panel, taking S3026C Switch as an example.
I. Front panel layouts
You can find the system state indicator, fixed Ethernet port indicator, 24 fixed
10Base-T/100Base-TX auto-negotiation Ethernet ports, 2 optional module slots, and
Console port located in order on the front panel of S3026C Ethernet Switch. See the
figure below.
Power indicator
24 100M electrical port state indicator
100M electrical port state indicator
Mode switch button
24 100M electrical port
Optional module
slot
Optional module
slot
CONSOLE port
Quidway S3000 Se ries
Power indicator
24 100M electrical port state indicator
100M electrical port state indicator
Mode switch button
24 100M electrical port
Optional module
slot
Optional module
slot
CONSOLE port
Quidway S3000 Se ries
Figure 1-4 S3026C Switch front panel
II. Front panel indicators
The meanings of the indicators on the front panel of S3026C are described in the
following table.
Table 1-5 S3026C Switch front panel indicators
Indicator Panel indication Status Description
On The switch is powered on.
PWR
Off The switch is powered off.
On Redundant power is working
System state indicator
RPS
Off Redundant power is not working
On/Blinking Data is being sent or received.
LNK
Off No data is being sent or received.
On Full-duplex mode
DUP
Off
Half-duplex mode
On 100M operating mode
Fixed Ethernet port
indicators
SPD
Off 10M operating mode