Huawei Quidway S3000-EI Series - II. Setting the command level used after a user logging in; III. Setting the command level used after a user logs in from a user interface

Installation Manual
Quidway S3000-EI Series Ethernet Switches
Chapter 3 Installation
3-9
connector. Users can choose one of them to fit the DB-9 (female) or DB-25 (female)
jack on the analog Modem as needed. The following figure illustrates the AUX cable.
Enlarged A side
Pos.1
Pos.25
DB25 Male
A
DB9 Male
Label
8P8C PLUG
B
Enlarged B side
Pos.1 Pos.8
Enlarged C side
Pos.9
Pos.1
C
Figure 3-10 AUX cable
Table 3-2 AUX cable connection
RJ-45 Signal Direction DB-25 DB-9
1 RTS
→
4 7
2 DTR
→
20 4
3 TXD
→
2 3
4 CD ← 8 1
5 GND - 7 5
6 RXD ← 3 2
7 DSR ← 6 6
8 CTS ← 5 8
3.4.2 Connection of AUX Cable
Step 1: Plug the RJ-45 connector of AUX cable into the Console port of the switch.
Step 2: Connect the DB-25 (or DB-9) male connector to the serial port of the analog
Modem.
3.5 Installation of the Optional Interface Modules
3.5.1 Installation of the Optional Interface Modules