Huawei Quidway S3000-EI Series - Rear Panel

Installation Manual
Quidway S3000-EI Series Ethernet Switches Chapter 1 Product Introduction
1-9
Table 1-10 Console port attributes
Attribute Description
Connector RJ-45
Standard of
interface
Asynchronous EI_A/TIA-232
Baud rate 9600bps (by default)
Services supported

Connect with character terminal

Connect with the serial port of a local terminal (which can be a PC) or a remote
terminal (through a pair of Modems) and run terminal emulation program on a
terminal.
V. Uplink 10/100/1000Base-T interface attribute
Table 1-11 S3026T Uplink 10/100/1000Base-T interface attributes
Attribute Description
Uplink interface number 2
Connector RJ-45
Operating mode

1000M full-duplex

10M full-duplex

100M full-duplex

Support MDI/MDI-X auto-sensing
Transmission medium
and maximum
transmission distance
Category-5 twisted pair cabling with a maximum transmission distance of 100m.
1.4.2 Rear Panel
I. S3026T Switch Rear Panel
 Rear panel layouts
You can find AC socket, grounding screw, and redundant power socket on the rear
panel of S3026T Switch. See the figure below.
AC power
Grounding screw
Redundant power inputAC power
Grounding screw
Redundant power input
Figure 1-8 S3026T Switch rear panel
 AC power input range
100 to 240V, 50/60Hz AC. Tolerance range: ±10%
II. S3026T-DC Switch rear panel
 Rear panel layouts
You can find DC power switch, DC socket, grounding screw, and redundant power
socket on the rear panel of S3026T-DC Switch. See the figure below.