Huawei Quidway S3000-EI Series - Module Panel and the Indicators; Module Interface Fiber

Installation Manual
Quidway S3000-EI Series Ethernet Switches
Chapter 7 Optional Interface Modules
7-5
Caution:
1) In the case that the optical interface does not connect with an optical connector or the dust-proof cap
is removed, it is possible for invisible rays to emit from this optical interface. Therefore, do not stare at
the optical interface.
2) If no optical connector is installed in the optical interface, make sure a dust-proof cap is placed on it.
3) Before connecting the optical fiber, make sure the connector matches the adopted optical fiber.
1000Base-LX GL module provides one Gigabit optical interface and uses Single
Mode optical fiber with a maximum transmission distance of 40km.
7.3.1 Module Panel and the Indicators
1000Base-LX GL module panel is illustrated in the following figure.
1000BASE-LX
GL MODULE
Class 1 Laser Product
LINK
ACTIVE
TX RX
Figure 7-5 1000Base-LX GL module panel
The descriptions of panel indicators are as follows:
Table 7-5 Meaning of indicators on 1000Base-LX GL module panel
Indicator Status description
LINK Off means that the line is disconnected. On means the line is connected.
ACTIVE Off means that no data is being received or sent. Blinking means data is being received or sent.
7.3.2 Module Interface Fiber
1000Base-LX GL module interface matches LC connector.
Figure 7-6 LC connector
The following table describes the interface attributes of 1000Base-LX GL module.