Huawei Quidway S3000-EI Series - Boot Menu

Installation Manual
Quidway S3000-EI Series Ethernet Switches
Chapter 5 BootROM and Host Software Loading
5-2
5.2.1 Boot Menu
Take S3026C Switch as an example. After being powered on, the switch runs the
BootROM program first and displays the following information on the screen:
Starting...
************************************************
* *
* Quidway S3026C BOOTROM, Version 120 *
* *
************************************************
Copyright(C) 2000-2003 by HUAWEI TECHNOLOGIES CO.,LTD.
Creation date: June 16 2003, 16:57:31
CPU type : MIPS
CPU Clock Speed : 150Mhz
Memory Size : 64MB
Initialize LS66LTSU......................................OK!
SDRAM selftest...........................................OK!
FLASH selftest…..........................................OK!
CPLD selftest............................................OK!
Port g1/1 has 1000BASE-SX MM module
Port g2/1 has 1000BASE-T GT module
Switch chip selftest.....................................OK!
Switch SDRAM selftest....................................OK!
PHY selftest.............................................OK!
Please check port leds.......................... ........OK!
The switch Mac is: 00-E0-FC-35-26-E0
Press Ctrl-B to enter Boot Menu... 5
Press <Ctrl+B>. The system displays:
Password :
 Note:
To access the Boot Menu, you should press <Ctrl+B> within five seconds after the information “Press
Ctrl-B to enter Boot Menu...” appears; otherwise the system will start to decompress the program. At this
time if you want to access the Boot Menu, you will have to restart the switch.