Huawei Quidway S3000-EI Series - S3026 G;S3026 G-DC Ethernet Switches; Front Panel

Installation Manual
Quidway S3000-EI Series Ethernet Switches Chapter 1 Product Introduction
1-2
 Note:
S3026G and S3026G-DC Switches share similar structures, except for their power sockets. Unless
otherwise specified, S3026G is introduced as a representative.
For the same reason, S3026C is introduced as a representative of S3026C and S3026C-DC.
For the same reason, S3026T is introduced as a representative of S3026T and S3026T-DC.
For the same reason, S3026E FS is introduced as a representative of S3026E FS and S3026E FS-DC.
For the same reason, S3026E FM is introduced as a representative of S3026E FM and S3026E FM-DC.
1.2 S3026G/S3026G-DC Ethernet Switches
1.2.1 Front Panel
 Note:
The front panels of S3026G and S3026G-DC Switches are exactly the same. This section introduces the
front panel of S3026G Switch as an example.
I. Front panel layouts
You can find the system state indicator, fixed Ethernet port indicator, 24 fixed
10Base-T/100Base-TX auto-negotiation Ethernet ports, 2 GBIC uplink ports, and
Console port located in order on the front panel of S3026G Ethernet Switch. See the
figure below.
GBIC module
slot
CONSOLE port
Quidway S3000 Series
Power indicator
24 100M electrical port state indicator
100M electrical port state indicator
Mode switch button
24 100M electrical port GBIC module
slot
GBIC module
slot
CONSOLE port
Quidway S3000 Series
Power indicator
24 100M electrical port state indicator
100M electrical port state indicator
Mode switch button
24 100M electrical port GBIC module
slot
Figure 1-1 S3026G Switch front panel
 Note:
GBIC is a kind of hot-swappable data communication card.
S3026G Switch provides 2 GBIC interfaces. You can select gigabit modules, all of which are
hot-swappable.