Installation Manual
Quidway S3526 Ethernet Switch Chapter 5 Booting and Configuration
5-6
5.4.2 Power on the Switch
I. Boot interface
After the switch is powered on, first run the BOOTROM program. The terminal display
provides the following output:
starting….
************************************************
* *
* Quidway S3526 BOOTROM, Version 2.00 *
* *
************************************************
Copyright(C) 2000-2002 by HUAWEI TECHNOLOGIES CO.,LTD.
Creation date: Oct 26 2001, 16:57:31
CPU type : MPC8240
CPU Clock Speed : 200Mhz
BUS Clock Speed : 33Mhz
Memory Size : 64MB
S3526R001 main board self testing..................... (1)
SDRAM fast selftest......................................OK! (2)
Please check port leds................Led selftest finished! (3)
Flash fast selftest......................................OK! (4)
Switch chip selftest.....................................OK! (5)
CPLD selftest............................................OK! (6)
Port g2/1 has no module (7)
Port g1/1 has no module (8)
PHY selftest.............................................OK! (9)
SSRAM fast selftest......................................OK! (10)
Press Ctrl-B to enter Boot Menu... 5 (11)
Line (1) to (10) indicates system selftest information, line (7) and (8) may be changed
based on different modules.
For the line (11), 5 seconds are kept for the instruction waiting:
If pressing <Ctrl+B> within the 5 seconds, the program will access the BOOT
menu. For specific description, see section 6.1.
If not performing any operation or press other keys other than <Ctrl+B> within the
5 seconds of waiting, system will enter the auto-booting state when the time
prompt for instruction waiting becomes 0.
To Next Page
Loading...
Need help?
General
