Installation Manual
Quidway S3526 Ethernet Switch Chapter 6 BootROM and Host Software Loading
6-11
III. Loading host software
Follow these steps to download the host software:
Step 1: Select <1> in Boot Menu. The system displays the following information:
1. Set TFTP protocol parameter
2. Set FTP protocol parameter
3. Set XMODEM protocol parameter
0. Return to boot menu
Enter your choice(0-3):3
You can select a different protocol to download host software.
The subsequent steps are the same as the steps taken to load the BootROM program,
except for the displayed prompt messages.
6.3 Remote Software Loading
If your terminal is connected to the switch by a network, you can load BootROM and
host software at the remote.
6.3.1 Remote Loading Using FTP
Run FTP Server on a local PC, provided you have configured username and password
and have set the correct file directory. Suppose IP address of the PC is 10.10.110.1.
Log onto the switch via Telnet to send host program to the switch using FTP.
Provided that the host program is SWITCH.app and the BootROM program is
SWITCH.btm, you can follow these steps after logging onto the switch by using Telnet.
Step 1: Download the software to the switch using FTP.
<Quidway> ftp 10.10.110.1
Trying ...
Press CTRL+K to abort
Connected.
220 WFTPD 2.0 service (by Texas Imperial Software) ready for new user
User(none):lyt
331 Give me your password, please
Password:
230 Logged in successfully
[ftp] get SWITCH.app SWITCH.app
[ftp] get SWITCH.btm SWITCH.btm
[ftp] bye
To Next Page
Loading...
Need help?
General
