Huawei RTN XMC ODU V200 - Changing Polarization Direction of the Antenna

14 14
Changing Polarization Direction of the Antenna
 The antennas are available in multiple types. This procedure for changing the antenna polarization direction is provided for
reference only. In actual installation, follow the instructions delivered with the antenna.
 By default, the antenna applies vertical polarization. If the antenna requires horizontal polarization in the network plan, the
polarization direction of the antenna should be changed.
1. Loosen the fastening screw ④ on feed boom ③ so that the feed boom can rotate freely.
2. Rotate the feed boom ① 90 degrees in a clockwise direction or an anticlockwise direction to ensure that the red
polarization identifier on the feed boom is aligned with the H identification line.
3. Adjust feed boom ① to align the four feed booms tabs ③ with the holes in the feed boom, and then tighten
fastening screw ④ on the feed boom.
Single-polarized antenna-vertically polarized Single-polarized antenna-horizontally polarized
Dual-polarized antenna-the feed
boom on the left is vertically polarized
Dual-polarized antenna-the feed
boom on the left is horizontally polarized
Installing the ODU
③
④
①
②