Huawei RTN XMC ODU V200 - Installing the Antenna Adapter on the Antenna

26
Installing the Antenna Adapter on the Antenna
The direction of the
waveguide cavity of the
antenna adapter and that
of the antenna feed boom
must be consistent.
②
①
Installing the ODU
1. Apply lubricant on the gasket ① of the antenna feed boom. (Note: End face ② should not be applied
with lubricant.)
2. Apply anti-seize grease to the four M6 captive screws ③ of the antenna adapter ⑤.
3. Install the antenna adapter onto the antenna. Keep the direction of the waveguide cavity consistent with that
of the adapter and ensure that one of the guide troughs ④ should face upwards.
4. Screw the four M6 captive screws ③ of the ODU about 30% and tighten them cornerwise.
⑤
③
④