15 15
Installing the ODU on the Antenna
1. Observe the position of the ODU guide pin . It is attached to the inner side of the ODU handle by default.
When the antenna is installed in horizontally polarized mode, secure guide pin ① to identifier H. Before
securing the guide pin, you should screw out the plastic screw ② at identifier H. When the antenna is installed
in vertically polarized mode, secure guide pin ① to identifier V. Before securing the guide pin, you should screw
out the plastic screw ② at identifier V. The following describes how to install the guide pin for horizontal-
polarized antennas.
The guide pin is used together with the guide through to facilitate the installation of the ODU.
Apply anti-seize grease to the screws on the guide pin.
2. Remove the dust-proof caps ① from the antenna port of the ODU and the antenna feed boom.
Installing the ODU
①
①
①
②
To Next Page
Loading...
