30
30
Tightening the bolts
d
Installing the OMT
c
Lead the OMT through the bolt heads as
shown, and then rotate the OMT counter
clockwise.
Ensure that the OMT is in proper contact with
the antenna.
Apply 18.7Nm(165.51 lbf.in)±5% force to tighten the bolts.
Install the M8 bolts
and tighten them
using the spanner
provided by the OMT
vendor.
Turn the OMT alternatively to
the left and right to align it.
Ensure that the OMT is
in a correct direction.
Installing the ODU
Installing the OMT
To Next Page
Loading...
