Huawei S6700 Series

l Configuring IP addresses for interfaces to ensure that neighboring switches are reachable
at the network layer
l Configuring Basic OSPF Functions
Data Preparation
To configure a stub area, you need the following data.
No. Data
1 (Optional) Cost of the default route to the stub area
NOTE
By default, the cost of the default route to the stub area is 1.
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
ospf [ process-id ]
The OSPF process view is displayed.
Step 3 Run:
area area-id
The OSPF area view is displayed.
Step 4 Run:
stub
The specified area is configured as a stub area.
NOTE
l All switches in a stub area must be configured with stub attributes using the stub command.
l Configuring or deleting stub attributes will update routing information in the area. Stub attributes can
be deleted or configured again only after the routing update is complete.
Step 5 (Optional) Run:
stub [ no-summary ]
The ABR is prevented from sending Type 3 LSAs to the stub area.
Step 6 (Optional) Run:
default-cost cost
The cost of the default route to the stub area is set.
To ensure the reachability of AS external routes, the ABR in the stub area generates a default
route and advertises the route to the non-ABR switches in the stub area.
S6700 Series Ethernet Switches
Configuration Guide - IP Routing 4 OSPF Configuration
Issue 01 (2012-03-15) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
117