Huawei SE2900 - Spuz0

HUAWEI SE2900 Session Border Controller
Hardware Description
1 Service Processing Device
Issue 01 (2016-01-15)
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
61
Item
Specifications
RH (non-condensing)

Short-term operating humidity: 5% RH to 95%
RH (non-condensing)
Short term means that the consecutive working period is not more than 96 hours and that the cumulative
working period over a year is not more than 15 days.
1.8.3 SPUZ0
Functions
Table 1-40 describes functions of the SPUZ0.
Table 1-40 Functions
Function
Description
Service
processing

Uses one Intel
®
Xeon
®
full-power, 8-core Sandy Bridge-EP CPU.

Provides four double data rate 3 (DDR3) memory channels, each for
installing one 16 GB registered dual in-line memory module
(RDIMM). The board offers with the maximum memory capacity of
64 GB.

Supports 800 MHz, 1066 MHz, and 1333 MHz RDIMMs.

Supports error checking and correction (ECC).
Interfacing

Provides two 1GE Base ports for communicating with Base planes of
multi-function switch units (MXUs) through the backplane.

Provides two 20GE Fabric ports for communicating with Fabric
planes of MXUs through the backplane.

Provides two 20GE Update interfaces for communicating with the
switching planes through the backplane.

Provides four enhanced small form-factor pluggable (SFP+) ports
and four SFP ports on the panel.
Management
Provides an independently powered baseboard management controller
(BMC). The BMC connects to the SMM through the Network Controller
Sideband Interface (NC-SI) bus. The BMC provides the following
functions:

Manages the field replaceable unit (FRU) information, sensor data
records (SDRs), and system event logs (SELs).

Detects the board temperature and voltage, reports alarms, and
controls the power-on, power-off, hot swap, and reset operations of
the board.

Supports serial port redirection.

Loads board software online.
Hot swap
The boards are hot-swappable.