Huawei SUN2000-150KTL-S0 - Page 50

PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
6 Installing a BIM
Issue 03 (2020-04-10)
Copyright © Huawei Technologies Co., Ltd.
44
Figure 6-1 Installing BIM cables (battery 1)
(1) Bolt
(2) Spring washer
(3) Flat washer
(4) OT terminal
(5) Battery connecting piece
The OT terminal must be installed on the battery connector. Otherwise, safety risks may
occur.
Figure 6-2 Installing BIM cables (battery 2)
(1) Bolt
(2) Spring washer
(3) OT terminal
Step 3 Connect the other end of the cables to the pin port on the BIM.
Step 4 Strip the adhesive tape from the BIM fastener.
Step 5 Attach the BIM to the battery.