PowerCube 5000 (SUN2000-150KTL-S0)
Installation Guide
9 Power-on and Commissioning
Copyright © Huawei Technologies Co., Ltd.
Step 2 Set the IP address, subnet mask, and gateway address on the LCD.
Table 9-12 IP parameters
Set this parameter according
to the address provided by
the network administrator.
Set this parameter according
to the subnet mask provided
by the network
administrator.
Set this parameter according
to the gateway address
provided by the network
administrator.
NOTE
If the Wifi module is installed,
do not set the default gateway
to 192.168.0.1, preventing
conflict with the Wifi gateway.
----End
9.4.3 Logging In to the WebUI
Procedure
Step 1 Set the PC IP address in the same network segment as the SMU IP address.
For example, if the SMU has an IP address of 192.168.0.10, a subnet mask of 255.255.255.0,
and a default gateway of 192.168.0.1, set the IP address to 192.168.0.11, subnet mask to
255.255.255.0, and default gateway to 192.168.0.1 on the PC.
Step 2 Enter https://Monitoring local IP address (for example, https://192.168.0.10) in the address
box of the browser, and then press Enter to access the WebUI login page.
To Next Page
Loading...
