SUN2000 (8KTL-28KTL)
User Manual
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 4-19 Securing a rear panel
Step 4 If the installation position is low and you can mount the SUN2000 on the rear panel, go to
Step 9 after performing Step 7.
Step 5 If the installation position is high and you cannot mount the SUN2000 on the rear panel,
perform Step 6 to Step 10.
Step 6 Remove the two rubber screws from the top of the SUN2000 using a flat-head screwdriver,
and install two M10 lifting eyes, as shown in Figure 4-20.
Figure 4-20 Installing lifting eyes
Step 7 Use one hand to hold the handle at the bottom of the SUN2000 and use the other hand to hold
the handle close to the top of the SUN2000 and then stand the SUN2000, as shown in Figure
4-21. Two persons are required to install the SUN2000.
To Next Page
Loading...
Need help?
General