Figure 5-26 Routing a cable
Step 3 Remove the cable terminal base from the terminal block, and connect the
communications cable to the terminal base.
Figure 5-27 Connecting cables to a terminal base
(1) RS485A IN
(2) RS485A OUT
(3) RS485B IN (4) RS485B OUT
Step 4 Land the cables in the terminal block, and bond the shield layer to the ground
point.
When connecting the shielded cable, crimp the OT terminal if required.
SUN2000-(50KTL, 60KTL, 65KTL)-M0
User Manual 5 Electrical Connections
Issue 11 (2024-02-02) Copyright © Huawei Technologies Co., Ltd. 64
To Next Page
Loading...
