● To prevent dust inhalation or contact with eyes, wear safety goggles and an
anti-dust respirator when drilling holes.
● Clean up any dust in and around the holes using a vacuum cleaner and
measure the distance between holes. If the holes are inaccurately positioned,
drill a new set of holes.
● Level the head of the expansion sleeve with the concrete wall after removing
the bolt, spring washer, and at washer. Otherwise, the mounting bracket will
not be securely installed on the concrete wall.
Step 3 Align the mounting bracket holes with the drilled holes, insert expansion bolts into
the holes through the mounting bracket, and then tighten the expansion bolts.
Figure 4-13 Securing a mounting bracket
----End
4.5 Installing the SUN2000
Installation Precautions
Before installing the SUN2000, take it out from the packing case and move it to
the installation position.
SUN2000-(50KTL, 60KTL, 65KTL)-M0
User Manual 4 Installation
Issue 11 (2024-02-02) Copyright © Huawei Technologies Co., Ltd. 36
To Next Page
Loading...
