Figure 5-19 Removing an SFP+ cable
2. Connect the new SFP+ cable.
Remove the dust-proof cap on the port, and insert the cable connector into
the port. See Figure 5-20.
When you hear a "click" sound and the cable cannot be pulled out, the connector is
securely connected.
Figure 5-20 Connecting an SFP+ cable
Step 6 Check that the new cable is properly connected.
Power on the server, and ping the IP address of the peer device. If the peer device
cannot be pinged, check whether the cable is intact or the connectors are securely
connected.
Step 7 Bind the new optical cable.
TaiShan 200 Server
User Guide (Model 2280) 5 Install and Congure
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 61
To Next Page
Loading...
