Set the PXE
● Setting the PXE for an LAN on motherboard (LOM)
a. Select Advanced and press Enter.
The Advanced screen is displayed, as shown in Figure 5-47.
Figure 5-47 Advanced screen
b. Select LOM Conguration > PXE Conguration and press Enter.
c. Set the PXE for NICs.
i. Select the network port such as PXE1 Conguration, and press
Enter.
ii. In the dialog box that is displayed, select Enable and press Enter.
d. Select PXE Boot Capability and press Enter. In the dialog box that is
displayed, select the PXE boot network protocol.
▪
UEFI: IPv4
▪ UEFI: IPv6
▪ UEFI: IPv4/IPv6
e. Press F10.
The system displays "Save
conguration changes and reset and exit?"
f. Select Yes and press Enter to save the setting.
● Setting the PXE for a NIC connected to the server
The displayed information varies according to the external NIC when you congure
the PXE. The following procedure uses the SP570 NIC as an example.
TaiShan 200 Server
User Guide (Model 2280) 5 Install and Congure
Issue 04 (2020-01-16) Copyright © Huawei Technologies Co., Ltd. 87
To Next Page
Loading...
