Huawei UAP2105 - Defining a Subscriber in the AHR; Adding a Zone; Figure 5-4 Logging in to the AHR

Procedure
Step 1 For details, see the description of PPPoE route mode in 5.1.1 PPPoE Mode.
NOTE
The method of setting the router in FE direct connection mode is the same as the method of setting the ADSL
modem in PPPoE route mode.
----End
5.2 Defining a Subscriber in the AHR
This describes how to define an AP subscriber in the AHR. To define an AP subscriber in the
AHR, create an AP zone, and then add an AP user to the zone.
5.2.1 Adding a Zone
This describes how to add an AP zone in the AHR. Before adding an AP zone, obtain the
information about neighboring macro cells around the AP cell and the IP addresses of the AP
Manager, AG, SeGW, and CLK used in the AP network.
5.2.2 Adding a User
This describes how to perform AP user management in the AHR, for example, add an AP user
in the AHR.
5.2.1 Adding a Zone
This describes how to add an AP zone in the AHR. Before adding an AP zone, obtain the
information about neighboring macro cells around the AP cell and the IP addresses of the AP
Manager, AG, SeGW, and CLK used in the AP network.
Prerequisite
l You have installed the AHR client that matches the version of the AHR server.
l You have obtained the IMSI of the SIM or USIM card used in the AP and the IP addresses
of the AP Manager, AG, SeGW, and CLK used in the AP network.
Procedure
Step 1 Start the AHR client, and then type the user name, password, and IP address of the AHR server,
as shown in Figure 5-4.
Figure 5-4 Logging in to the AHR
UAP2105
User Guide 5 Configuring the UAP2105
Issue 03 (2009-08-20) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-5