Option Description
Time Setting It is used to specify the time for starting the upgrade.
If the upgrade mode is set to Timer, this option is
enabled.
3. Click Next. On the displayed page, select the target APs.
You can select the target APs on the AP Manager in the following two ways:
– Special Terminal: indicates that you directly select APs to be upgraded.
– Special Condition: indicates that you select APs to be upgraded by special
conditions.
4. Click Submit to complete the settings.
If You Set Immediately Reboot to ... Then …
Yes The AP is rebooted immediately for
upgrade after the software is
downloaded successfully.
NOTE
Rebooting the AP disrupts the services
provided by the AP.
No After the software is downloaded
successfully, check whether services
are provided, and then reboot the AP.
l If no service is provided, reboot the
AP for upgrade immediately.
l If services are ongoing, reboot the
AP for upgrade after services are
performed.
----End
6.5 Uploading AP Terminal Files
This describes how to upload the AP log, configuration file, and performance file to the FTP
server through the AP Manager for future analysis, use, or query.
Prerequisite
The FTP server is available.
Log in to the AP Manager, and then choose Software > File Server. On the File Servers tab
page, check Status of the corresponding FTP server.
If
Status of the FTP Server is ...
Then …
Available The AP Manager communicates with the FTP
server normally.
6 Routine Operation and Maintenance of the UAP2105
UAP2105
User Guide
6-8 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
