6.1 Commissioning Services
This describes how to trace the Uu interface, Iu interface, and CDT messages to test the services
offered by the AP through the Trace Viewer tool of the Local Maintenance Terminal (LMT).
Prerequisite
l The AP is powered on, and the AP cell is set up.
l Two functional UEs, UE 1 and UE 2, are ready.
l If the admission mode of the AP is set to Close or Group, the IMSIs of UE 1 and UE 2 are
added to the AP permission list.
For details about how to configure the AP permission list, see the AHR Operator Guide.
l A functional fixed-line phone is ready.
l The LMT that matches the AP version works properly.
l The CS and PS domains are functional.
Context
Table 6-1 describes the basic tasks involved in service commissioning.
Table 6-1 Commissioning AP Services
Task
Method Expected Result
Test voice call services. UE 1 or UE 2 originates a
voice call to the fixed-line
phone.
The voice quality is good
without loud noise.
UE 1 originates a voice call to
UE 2.
The voice quality is good
without loud noise.
Test video call services. UE 1 originates a video call to
UE 2.
l The voice is clear.
l The video is clear and
fluent.
l The voice is synchronized
with the video.
Test PS services. Browse web pages and upload
or download data through a
UE.
Web pages are browsed
normally, and data is uploaded
or downloaded successfully
within the specified time.
Procedure
Step 1 Log in to the LMT, and then choose Service > Trace Management > Interface Trace Task
to trace the Uu interface, Iu interface, and CDT messages, as shown in Figure 6-1.
6 Routine Operation and Maintenance of the UAP2105
UAP2105
User Guide
6-2 Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Issue 03 (2009-08-20)
To Next Page
Loading...
