8. Return dial to AUTOMATIC (program will water the entire program
beginning with the station number last left in the display, then
controller will return to automatic mode with no change in the
previously set program).
NOTE: The station that is on the display when you turn
the dial to AUTOMATIC will be the first station to run.
The controller will then proceed to water in sequential
order only. It will not water previous stations.
One Touch Manual Start and Advance
You can also activate all stations to water without using the dial.
1. Hold down the button for 2 seconds.
2. This feature automatically defaults to program A. You can select
program B or C by pressing the program.
3. The station number will be flashing. Press the button to scroll
through the stations and use the or button to adjust the sta-
tion run times. (If no buttons are pressed for a few seconds dur-
ing step 2 or 3, the controller will automatically begin watering.)
4. Press the
button to scroll to the station you wish to begin with.
After a 2 second pause, the program will begin.
HIDDEN FEATURES
Programmable Delay Between Stations
This feature allows the user to insert a delay between when
one station turns off and the next station turns on.
1. Start with the dial in the AUTOMATIC position.
2. Press and hold the
button down while turning the
dial to the SET STATION RUN TIMES position.
3. Release the
button. At this point the display
will show a delay time for all stations in seconds,
which will be blinking. The DELAY icon shall also
be lit at this time.
4. Press the
and buttons to increase or decrease
the delay time between 0 and 1 minute 40 seconds
in 5 second increments.
5. Return the dial to the AUTOMATIC position.
Clearing the Controller's Memory/Resetting the Controller
If you feel you have misprogrammed the controller, there is a process
that will reset the memory to factory defaults and erase all programs
and data that has been entered into the controller.
1. Press and hold down the , and buttons.
2. Press and release the reset button in the lower wiring compartment.
3. Release the , and buttons. The display should now show
12:00 am. All the memory has been cleared and the controller may
now be reprogrammed.
10
To Next Page
Loading...
