GENESIS OPERATIONS MANUAL
21
TO SET THE OPTION
After you select a Program (and a Start, if necessary) and an option, follow the steps for setting that o
ption:
Option #1
-
Cluster On Times
With this option, you can set a group or range of stations to run the same length of time. For example, you can set
stations #2 through #5 to run ten minutes each.
Select the Program and Start you want to set Run Tim
es for. Then, when you select option #1, the display shows:
Cluster On Times
Begins the process of setting this option. The display changes to:
RunTime? <off>
Press number key(s) for the Run Time you want to set for a group of stations. This
exa
mple shows ten minutes:
Run Time 0:10M
Note: The time mode (M or S) is dependent on the setting of Option #7. If you want to change modes, see Option
#7.
Sets the length of the Run Times in this group of stations. The display shows:
From
--
To
--
Press the number key for the first station in the group. If you press ENTER instead of
entering a number, the display shows 1.
Completes your selection of the first station. In this example, the display shows:
From 2 To xx (xx = highest stati
on #in the controller)
Press the number key for the last station in the group. In this example, the display shows:
From 02 To 05
Note: If you press ENTER instead of entering a number, the setting will include all stations from the first in the
gr
oup to the highest station number in the controller.
Completes the option setting. The display shows:
DONE!
Exits the function, restores the time display.
To Next Page
Loading...
Need help?
General
