GENESIS OPERATIONS MANUAL
22
Option #2
-
Copy Run Times
With this option, you can copy Run Times within a Program from o
ne Start to another. For example, in Program
#1 you can copy the Run Times already set for Start #1 to Start #2.
First, specify the Program/Start you want the Run Times copied
to
. Then, when you select option #2, the display
shows:
Copy RunTimes?
Be
gins the process of setting this option. The display changes to:
Copy from P1 T?
This example shows that you're in Program #1, and asks which Start to copy
from
.
Press number key(s) for the Start you want to copy Run Times
from
. The example in thi
s display will
copy the Run Times from Start #1:
Copy from P1 T1_
Sets the Program to copy the Run Times from Program #1, Start #1. This display shows:
Copied!
Exits the function, restores the time display.
Option #3
-
Hrs:Min or Min:Sec
This
option changes the time setting mode for all stations in a Program/Start. The M mode (Hours: Minutes)
ranges from 1 minute to 4 hours:15 minutes, in one
-
minute increments. The S mode (Minutes: Seconds) ranges
from 1 second to 4 minutes:15 seconds, in on
e-
second increments.
Select the Program/Start you want to change. Then, when you select option #3, the display shows:
P1 T1 Minutes?
This display indicates the current mode is hours and minutes. Run Time displays in this mode show a letter M:
1:30M
This example means one hour and 30 minutes. If you enter 90 minutes for a Run Time while in this mode, the
display shows 1:30M.
Changes the mode to minutes and seconds:
P1 T1 Seconds?
Run Time displays in this mode show a letter S: