GENESIS OPERATIONS MANUAL
27
This display indicates the pump will be enabled when P1 is running. You can use the AM/PM/? ke
y to toggle back
and forth between Yes and No.
Changes the display to:
P1 Pump? No
This display shows that the pump will be disabled when P1 is running.
Exits the function and restores the time display.
Option #9
-
Skip Days
This option causes
the Program to skip a specified number of days. It can also be used to review the number of
days remaining before normal starts resume.
Select the Program you want to skip days. Then, when you select option #9, the display shows:
P1 SkipDays <xxx>
Press the number key(s) for the number of days you want the Program to skip. In this example, the
display shows the Program will skip seven days, then resume normal starts:
P1 SkipDays 7
Completes the Skip Days setting and changes the display to:
P
1 SkipDays= 7
Exits the function, restores the time display.
HOW TO ERASE ALL PROGRAMS FROM MEMORY
To erase all Programs and load the default Program (if set in Option #12), follow these steps:
Prepares the system to clear all Programs from memor
y.
Prepares the system to clear all Start times from memory.
Press the zero key to clear all Programs and Start times.
To Next Page
Loading...
Need help?
General
