15
Connecting a Hunter “Clik” Weather Sensor (continued)
Testing the Weather Sensor
The Pro-C provides simplified testing of a rain sensor when
the sensor is wired into the sensor circuit. You can manually
test proper operation of the rain sensor by using the One
Touch Manual Start (see page 25). During the Manual cycle,
pressing the test button on the “Clik-type” sensor
(e.g., Mini-Clik
®
)
will interrupt watering.
NOTE
The Manual single-station function ignores any attached sensor
and will allow watering to occur.
Manually Bypassing the Weather Sensor
If the rain sensor is interrupting irrigation,
you can bypass it by using the bypass switch
on the front of the controller.
Slide the switch to the Bypass position
to disable the rain sensor from the system to
allow for controller operation. You can also bypass the weather
sensor for manual operation by using the Manual function.
The Bypass switch does not affect the Seasonal Adjust update
when using the Solar Sync sensor.
To Next Page
Loading...
Need help?
General
