Hunter Pro-C User Manual

14
Connecting a Hunter “Clik” Weather Sensor (not included)
A Hunter weather sensor or other micro-switch-type weather
sensors can be connected to the Pro-C. The purpose of this
sensor is to stop automatic watering when weather conditions
dictate.
1. Remove the metal jumper plate that is attached across
the two SEN terminals inside the controller.
2. Connect one wire to
one SEN terminal, and the
other wire to the other
SEN terminal.
When the weather sensor
has deactivated automatic
watering, “OFF” will appear
on the display.

Hunter Pro-C Specifications

General

Start Times Per Program	4
Warranty	2 years
Cycle + Soak	Yes
Display	LCD
Housing Material	Plastic
Zones	6, 8, 12, 16 (depending on model)
Indoor/Outdoor	Indoor
Mounting	Wall-mount
Electrical Input	120V AC, 60Hz
Transformer Output	24V AC
Number of Stations	6, 8, 12, 16 (depending on model)
Wireless Capability	No