34
Hidden Features (continued)
Accessing the Soak Menu:
Once the desired Cycle times for each station have been
programmed, the Cycle time can be accessed by pressing the
n button.
The station will remain the same as was previously displayed
under the Cycle time (i.e., if station 2 is displayed in the Cycle
menu then Station 2 will be displayed upon pressing the
n button).
NOTE
The Soak menu cannot be accessed without a programmed
Cycle time.
Setting the Soak Time:
To access the other stations, press the h or i button.
NOTE
When changing the stations, if a station without a Cycle time
is encountered, the screen will revert back to the Cycle time.
Move to the next station with a Cycle Time and press the n
button to return.
Once the desired station is displayed, the user can use
the j or k button to increase or decrease the Soak time.
The user can set the Soak time from 1 minute to 4 hours
in 1 minute increments.
NOTE
Before 1 hour, only minutes are displayed (e.g. 36). At 1 hour
or above, the display will change to include the hour digit
(e.g. 1:13 and 4:00).
Cycle and Soak Situations:
Station 1 requires 20 minutes of
watering, but after 5 minutes,
runoff occurs. However, after 10
minutes all the water is absorbed.
The solution would be to program
20 minutes for the station run time,
5 minutes for the Cycle time, and 10
minutes for the Soak time.
Example of Soak screen with
only minutes
Example of Soak screen with
hours included
Station 10 cycle running
To Next Page
Loading...
Need help?
General
