Hunter ROAM XL User Manual

19
PREPARING THE RECEIVER FOR USE
Your ROAM XL System is pre-addressed to work
right out of the box. However, if you changed the
Transmitter address as described in the section,
Preparing the Transmitter For Use", you must allow
the Receiver to learn the new address.
This can be done by performing the simple steps on
the next page.
a
a NOTE: Once a new address is
learned, the only way to remove the
address from the Receiver memory
is to repeat the steps, to learn a
different address.
a
a NOTE: The ROAM XL remote receiver
should not be permanently installed
in an outdoor or unsheltered location.

Hunter ROAM XL Specifications

General

Brand	Hunter
Model	ROAM XL
Category	Remote Control
Language	English