20
CHANGING THE RECEIVER ADDRESS
1. Before setting the receiver address, make sure
that the transmitter address is set to the address
you would like to use.
2. Plug the receiver into a SmartPort
®
connected
to a powered controller. When this is done, the
receiver will beep 4 times.
3. Once the receiver beeps 4 times, you have
approximately 7 seconds to send the new
address to the receiver. Press either the
or
button on your transmitter to connect.
4. The receiver will beep 4 additional times
indicating that it has learned the new transmitter
address and will respond only to that address
from this point on. If 8 seconds expire before the
or
button is pressed, the receiver will beep
twice and retain its original address.
a
a The ROAM XL transmitter may also be
used with existing ICR-R receivers, if they
are addressed to work with one another.
Hold the green button on the ICR-R
receiver, while plugging it into the
SmartPort.
Immediately after it beeps 4 times,
transmit with the ROAM XL to set the
new address.
To Next Page
Loading...
Need help?
General
