Hunter ROAM XL - WIRING HARNESS;SMARTPORT CONNECTION KIT

6
WIRING HARNESS/SMARTPORT
®
CONNECTION KIT
To use the ROAM XL Remote Control System, your
controller must be equipped with the SmartPort
®
wiring/harness connection kit. This wiring harness
provides the connection port where the ROAM XL
receiver is attached.
The SmartPort
®
wiring harness is included with the
purchase of the ROAM XL. Additional SmartPort
wiring harnesses may be purchased separately to
allow you to use the transmitter and receiver with
additional Hunter controllers.
The SmartPort Wiring Harness is not required with
Hunter ACC and I-Core commercial controllers.
These units are pre-wired with a SmartPort connector
already installed.