Hunter SRR - Page 7

3
This section will give you a brief description of the
components of the SRR. Each item will be discussed
in further detail later, however this section can be
helpful in getting acquainted with the Transmitter,
Receiver, and SmartPort
®
.
TRANSMITTER
A. LCD Display
1. Run Time – Indicates the Station Run Time is
being set when flashing.
2. Transmit – Indicates that the Transmitter
is transmitting the programmed data to the
receiver.
3. Main Display – Indicates various times and
values.
Number – Indicates either Station Run Time (1
to 30) or Station number (1 to 48).
On – Indicates Transmitter is turning on a
particular station.
Off – Indicates Transmitter is turning off a
particular station.
Program (A, B, C) – Indicates program
selected.
4. Address – Indicates that a new address for
transmitting between the Transmitter and the
Receiver is being set.
B. Control Buttons
5. – Increases the selected flashing display.
6. – Decreases the selected flashing display.
7. – Selects the selected flashing display.
8.
– Cancels the selected flashing display.
C. Other
9. Battery Cover – Covers compartment for 9-
volt alkaline battery.